![]() ![]() What To Do If The Plaster Wall Starts CrumblingĪ potential issue with old plaster is damaging the wall while removing the paper. Turn off fans and air vents to the work area to avoid drying the remover out.Work a section at a time, so the remover doesn’t dry out.Turn off the electricity to the room you are spraying in.Continue scoring, spraying and scraping until complete. Once the test area has been removed, you will have a good idea of how you will need to proceed with the rest of the removal process. Spray again, wait 15 minutes, and attempt to remove the paper again. If the wallpaper doesn’t come away easily from the plaster, don’t force it. It should come off easily, which will give you an idea of how well the paper was adhered to the wall. Start at an edge or seam and peel off the old paper.Allow 10-15 minutes for the gel to dissolve the old adhesive.Spray gel remover over the area, keeping it moist but not soaked.Be sure to use the scoring tool in a circular scrubbing motion, and remember that only light pressure is needed. Using the scoring tool, roll it over an area about 2-feet square. It is always recommended to start the process with a test area to anticipate any problems beneath the wallpaper. The remover does the hard work and eliminates much of the hard scraping. The most straightforward, efficient, and economical method for removing old wallpaper from plaster walls is to use a gel wallpaper remover. START STRIPPING THE WALLPAPER FROM THE PLASTER WALLS The added wheel helps balance the tool to prevent gouging the drywall. The scraper features a honed steel blade, specially set to glide and lift the paper from the wall.This reduces the need to continually reapply remover, and helps to keep the work area clean. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |